Forums » Mechanical

Assembly and Installation of a CNC Router

    • 200 posts
    February 14, 2019 6:55 AM PST

    Assembly and Installation of a CNC Router

    For the sake of knowledge of Z4E Members: pictures of assembly and installation of a CNC Router, currently in development stage. It is a 3-Axis/5-Motor CNC Router (X/Ax, Y/By, Z). The Roeli connection diagram is for 3-Axis/3-Motor CNC Router (X, Y, Z) only but it was used as general wiring.

    • 200 posts
    February 14, 2019 7:11 AM PST

    half way done, half way to go...

    • 200 posts
    February 14, 2019 7:16 AM PST

    Took 3 days to complete the circuit wiring, it is now ready for point-to-point cable testing offline. Colors of cables, zip-ties and connection bars following Roelli & ABNT standards. Connection bars pinout sequence is similar to the Controller board.

    • 19 posts
    February 14, 2019 11:26 AM PST

    Great Job Alex. Keep it up and let us update for farther progress.

    • 149 posts
    February 14, 2019 11:27 AM PST

    Very good. Keep sharing more photos

    • 1 posts
    May 12, 2019 12:41 AM PDT

    In our physics subject our teacher said that then if you make the route then you need to learn the way to connect the wires. I know about the bestessay team they all are good connector and they running a academy where they teach their students how they connect the route.