Forums » Electrical Engineering

Panel schedule design for load balancing.

    • 6 posts
    January 7, 2020 12:39 PM PST

     Will it not be correct if I do the load balancing on a panel and put all my loads on the right side with a balanced loads for each phase. Is there any different doing so instead putting loads on both sides and then balancing?

    Thanks

    • 157 posts
    January 7, 2020 3:14 PM PST

    It does not matter if all the overcurrent protective devices are on one side of the panel.  The bus bar delivers the loads to all 2 or 3 phases on one side of the panel anyway so that should not be an issue.